Elektral ThruScan Uživatelský manuál stáhnout pdf (Strana 46)

7.11 Queue Barrier

Chrome plated, 90 cm height, weights approx. 9 kg, 2.5 m length and 48 mm

thick red ribbon with yellow ThruScan logo print. 76 mm Pole diameter with

inbuilt automatic winding mechanism. Quadruple ribbon fixing joints enabling

versatile usage. Steady stand with carved design flange.

7.12 Hand-Held Metal Detector



Hand-Held Metal Detectors are widely used before hands-on searching of

alarmed visitors after Walk-Through Metal Detectors. Also the portable

screening solution enables checkpoint procedures at places where there is

no Walk-Through Metal Detector. For more detailed information please

refer to products section. ThruScan dX and dX-X HHMDs operate at very

low mA levels (Stand by: max. 5 mA, Alarm: max. 15 mA) enabling professional solutions with their

high sensitivity and long operation hours.

7.13 ShoeScan Metal Detector

ShoeScan detects threats with audio-visual alarm indication reliably without

the need to remove shoes. It has Very High Throughput Rate of 60 Person/Minute. ShoeScan

Detects all Metals both ferrous and non-ferrous. ShoeScan has adjustable sensitivity feature.

Built-In Battery Back-Up Feature against Electricity Cut Off.

8. MAINTENANCE & REPAIR

8.1. PERIODIC MAINTENANCE

Periodic maintenance requires that you inspect for loose or damaged parts and clean the surface of

the ThruScan

‘s exterior. The following procedure is recommended;

1. Open the rear cover of the Control Unit and ensure that all connectors are snapped and screwed

securely,

2. Inspect the windows of the “IR Pass Sensors” to ensure they are not obstructed,

3. Ensure that the eight bolts that attach the “Control Unit” and “Back Fixing Crosspiece” to the

side panels are in place and tight,

4. Ensure that the archway sits flatly on the floor and does not sway or rock,

5. Ensure that the power cord and cable to remote WTMDs are in good condition. If defected

replace immediately,

6. Clean exterior surfaces with damp cloth. Use only denatured alcohol for heavy-duty cleaning.

Please remember that the plastic parts are made by ABS and the metallic parts are painted by

electrostatic epoxy paint.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 56 57

Žádné komentáře

Elektral ThruScan Uživatelský manuál Strana 46