Elektral ThruScan Uživatelský manuál stáhnout pdf (Strana 43)

4 External trigger for capture

4.1 Activation depends on which camera is active.

4.2 If ch1 is in view, if TG1 active, capture a photo from ch1, if TG2 active, the system will switch

to ch2 and take a photo from ch2 then keep the ch2 in view, until manual change to ch1.

4.3 If both channels has triggered at the same time, the first triggered channel will be valid.

5 Playback the photo inside the memory

The captured photos will be stored in different folders for easy searching. The folders are named

according to the date sequence. If there is no file in the memory, it will show “NO FILE” and enter

view mode.

5.1 press

button to enter playback mode

5.2 press (OK) to enter thumbnail view, press again (OK) to normal view

5.3 use (V - / V +) button to forward or rewind the image

5.4 press (CH +) to turn on off the OSD

5.5 press

to show folder name, use (CH + / CH -) key to scroll, OK to select

6 Delete files from memory

6.1 At playback mode, press

to enter playback

menu, by using( V - / V +)key, one can select delete

current image or all files in the current folder. Press

OK to confirm and reconfirm by selecting a tick icon.

6.2 One can select format to delete all files in all folders

Delete Menu

7 System Setup

At preview mode, press

Set Up Screen

7.1 Set up Date time

7.1.1 Use (V -/V +)key to select date or time and (CH +/ CH -)

key to set the correct digit. The setting will then

store into system. Press ( OK ) to confirm.

7.2 Set up auto capture – enable or disable

7.2.1 Press ( OK ) to toggle enable or disable

7.3 Set up the capture format – AVI or Photo

7.3.1 Press ( OK ) to toggle AVI or Photo, press (V -/V +)

key to select next.

7.4 Advance Setup

7.4.1 Set up the auto return preview. When there is

a long idle time at non-preview mode, user

can select to enforce system to enter preview

mode Press ( OK ) to toggle not return or auto

return preview in 10 or 30 second

7.4.2 Set up the image quality: Press ( OK ) to toggle

HQ or SQ(default is HQ)

7.4.3 Set up motion detect count: default is 1, press

( OK ) to select from 1 to 10, this means the

number of images will be captured at every

trigger. Use (V -/V +) move to other item

7.4.4 Set up motion detect interval: default is 1, press ( OK ) to select from 1to 9, the bigger

figure the longer interval to active the detection. Setting n is about n+2 sec between 2

snap shot.

7.4.5 Set up motion detect sensitivity, use ( OK ) to select Hi, Mid, Lo, default is Hi

2 rev 1.0

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 56 57

Komentáře k této Příručce

Žádné komentáře

Elektral ThruScan Uživatelský manuál Strana 43

Komentáře k této Příručce